Run/Stop
This parameter specifies run and stop.
When
trol is stopped. When control is stopped, the
Default is
Function
Alarm value 1
This parameter sets the input value X" in the alarm type list.
• This parameter is used for setting the alarm values of alarm outputs.
• During temperature input, the decimal point position is dependent on the currently
selected sensor, and during analog input it is dependent on the decimal point"
Function
parameter setting.
Setting Range
-1999 to 9999
Setting
The alarm type must be set to other than upper and lower limit alarm.
F Related parameters
Input type" Scaling upper limit" Scaling lower limit" Decimal point"
See
Alarm 1 type" (initial setting level)
Alarm 1 open in alarm" Alarm 1 hysteresis" Standby sequence reset method"
Alarm latch" (advanced function setting level)
: run" is selected, control is running. When
".
Unit
EU
Operation Level
: stop" is selected, con
display lights.
The alarm type must be set to other than
upper and lower limit alarm.
Default
0
5–7