Hole Punch Mode - Canon imageRUNNER 3530 Reference Manual

■ Hole Punch Mode

The Hole Punch mode punches two or three holes (depending on the paper size) in the
printed sheets.
NOTE
•
The hole punched areas are shown in the illustration below.
Platen Glass
•
The distance between the punch holes is shown in the illustration below.
4 1/4"
(108 mm)
Three Holes
IMPORTANT
•
The Hole Punch mode is available only if the Puncher Unit-R1 is attached.
•
Only the following paper sizes can be hole punched: 11" x 17", LGL, LTR, or LTRR.
•
Holes cannot be punched in transparencies, envelopes, tracing paper, or labels.
•
The machine automatically selects how many holes to punch depending on the selected
paper size.
- Two holes:
- Three holes:
Hole
Punched
Area
Hole
Punched
Area
4 1/4"
(108 mm)
LGL, LTRR
11" x 17", LTR
Feeder
Hole
Punched
Area
Hole
Punched
Area
2 3/4"
(70 mm)
Two Holes
Finisher-S1/Puncher Unit-R1
3
3-21