Error And Status Messages On The Screen - Ricoh SP 210 SU User Manual

Error and Status Messages on the Screen

Messages are listed in alphabetical order in the table below.
"X" indicates the parts of the messages that appear differently depending on a specific situation, such as
the paper sizes, paper types, or tray names.
Message
2XXX14 The machine was not able to
print the received fax, or the
machine's memory reached
capacity while receiving a fax
because the document was too
large.
ADF Orig. Misfeed An original has been jammed
inside the ADF.
Open ADF Cover
and remove paper.
Causes
• The paper tray was empty. Load
• The paper tray did not contain A4,
• A cover or tray was open. Close the
• There was a paper jam. Remove the
• A print cartridge was empty. Replace
• The received fax was too large. Ask
• Remove jammed originals, and then
• Check the originals are suitable for
Error and Status Messages on the Screen
Solutions
paper in the paper tray. See page 41
"Loading Paper".
Letter, or Legal size paper. Load valid
size paper in the tray, and configure
the paper size settings under [System
Settings] accordingly.
cover or tray.
jammed paper. See page 202
"Paper Feed Problems".
the print cartridge. See page 195
"Replacing the Print Cartridge".
the sender to resend the document in
parts as several smaller individual
faxes, or to send at a lower
resolution.
place them again. See page 202
"Paper Feed Problems".
scanning. See page 49 "Placing
Originals".
217