JVC UX-A10DVD Service Manual page 9

Removing the MD mechanism assembly
Prior to performing the following procedure, remove
the metal cover, the DVD mechanism assembly and
the front panel assembly.
1. Remove the two screws
mechanism attaching bracket.
2. Remove the two screws L on each side of the MD
mechanism assembly
mechanism assembly toward the front.
3. Disconnect the card wire from connector CN521 on
the MD mechanism assembly board.
Removing the headphone board
Prior to performing the following procedure, remove
the metal cover, the DVD mechanism assembly and
the front panel assembly.
1. Disconnect the wire from connector CN310 on the
main board on the left side of the body.
2. Release the wires from the two clamps on the
bottom chassis.
3. Remove the screw
board on the right side of the body.
Main board
CN310
(See Fig.19~21)
K attaching the DVD
and remove the
(See Fig.22,23)
M attaching the headphone
Headphone board
Clamp
Fig.22
MD
MD mechanism assembly
MD mechanism assembly
L
MD mechanism assembly
Headphone board
K
DVD mechanism
attaching bracket
Fig.19
DVD mechanism attaching bracket
Fig.20
CN521
Fig.21
M
Fig.23
UX-A10DVD
L
1-9