JVC UX-A10DVD Service Manual page 6

UX-A10DVD
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and the DVD mechanism assembly.
1. Disconnect the card wire from connector CN705 on
the microcomputer board in the center of the right
side of the body.
2. Disconnect the card wire from connector CN301 on
the main board in the center of the left side of the
body.
3. Disconnect the card wire from connector CN704,
and the wires from CN703 and CN710 on the
microcomputer board.
ATTENTION: When disconnecting the wires from
CN703 and CN710, remove the
spacer attaching the wires.
4. Disconnect the card wire from connector CN442 on
the FL connection board on top of the body.
5. Remove the screw D on each side of the body.
6. Remove the two screws
body.
7. Release the joint a on the bottom and the two joints
b on the right and left sides of the body using a
screwdriver. Remove the front panel assembly
toward the front.
FL connection board
CN710
1-6
(See Fig.7~10)
E on the bottom of the
CN442
Front panel assembly
Spacer
Microcomputer board
CN703
CN704
Fig.9
Front panel assembly
D
b
Fig.7
CN710
CN703
Main board
CN301
Fig.8
E
a
Fig.10
Microcomputer board
CN705
Front panel assembly
Spacer
D
Microcomputer board
b
CN704
Front panel assembly
E