Table of Contents
Advertisement
4.
Reattach the wire holder to the UD base while fitting
the bending q to the hole of the wire holder (The
boss on the back of the wire holder is fit to the hole
of the UD base)(see Fig.21).
5.
Reattach the cam switch board using the two screws
I .
6.
Turn the cam switch until the boss comes to the
position marked with a triangle (see Fig.23).
Reattach the cam gear while fitting the cam gear slot
to the cam switch boss, and fix them using the slit
washer.
CAUTION:
When reattaching the cam gear with
fitting the slot to the cam switch boss,
make sure that part r of the gear is
aligned with the position marked with a
triangle of the cam gear.
7.
Reattach the loading motor assembly using the
screw G (see Fig.23).
Connect the wire extending from the loading motor to
connector CN612 on the switch board, set on the
bending s of the UD base and fix using the wire
holder.
Bending s
Loading motor assembly
G
Slide bar
CN612
Eject bar
Wire holder
Slit washer
Cam gear
Fig.23
UX-A10DVD
Mark
Boss
Cam switch
Cam switch board
Cam gear
(Marked with
a triangle)
Eject bar
part r
1-33
Advertisement
Table of Contents
