Table of Contents
Advertisement
UX-A10DVD
Removing
the
mechanism control board
1.
Turn over the cassette mechanism assembly and
remove the three screws
amplifier & mechanism control board.
2.
Disconnect the flexible wire from connector CN31 on
the head amplifier & mechanism control board.
3.
Disconnect connector CN32 of the head amplifier &
mechanism control board from connector CN1 on
the reel pulse board.
REFERENCE:
If necessary, unsolder the 4 pin wire
soldered to the main motor.
Removing the main motor (See Fig.4~7)
1.
Remove the two screws B .
2.
Half raise the motor and remove the capstan belt
from the motor pulley.
ATTENTION:
Be careful to keep the capstan belt
from grease. When reassembling,
refer to Fig.6 and 7 for attaching the
capstan belt.
Capstan belt
1-36
head
amplifier
(See Fig.4)
A attaching the head
Main motor assembly
Motor pulley
Fig.6
&
Head amplifier & mecha control board
CN31
Flexible wire
Capstan belt
Fly wheel
Capstan belt
A
CN32
B
A
4pin wire
Main motor assembly
Fig.4
Main motor assembly
Fig.5
Main motor assembly
Motor pulley
Fig.7
Advertisement
Table of Contents
