Table of Contents
Advertisement
UX-A10DVD
<Loading assembly section>
Removing the slide base (L) and (R)
1.
Remove the two screws F on the upper side of the
loading base assembly.
2.
Remove the slide base (L) outward while releasing
the two joints f on the bottom.
3.
Remove the slide base (R) outward.
Removing the loading mechanism assembly
1.
To release the loading mechanism assembly from
the bending g without trouble, first bring up the one
side of the loading mechanism assembly opposite to
the bending g and release the side bosses from the
loading mechanism base. And next, remove another
side.
Loading mechanism assembly section
Removing the loading motor
1.
Release the harness from the wire holder on the cam
switch board and disconnect from connector t.
2.
Remove the screw G and release the joint h .
3.
Remove the belt from the loading motor assembly.
4.
Remove the two screws H .
Remove the cam gear and the cam switch
board
1.
Remove the slit washer and pull out the cam gear.
2.
Release the harness from the wire holder on the cam
switch board and disconnect from connector CN612.
3.
Remove the two screws I , the clamp and the cam
switch board.
1-28
(See Fig.10)
(See Fig.11)
Loading mechanism assembly
Loading motor assembly
(See Fig.12, 13)
G
(See Fig.12)
Slide base(R)
Joint f
Joint f
Fig.10
Bending g
Loading mechanism base
Fig.11
Wire holder
Joint h
CN612
Fig.12
Loading motor
Fig.13
F
Slide base(L)
F
I
Cam switch board
Slit washer
I
Cam gear
H
Belt
Advertisement
Table of Contents
