JVC UX-A10DVD Service Manual page 14

UX-A10DVD
Removing the FL connection board
1. Remove the two screws
attaching the bracket (2) on the back of the front
panel.
2. Disconnect the card wire from connector CN441 on
the FL connection board.
3. Push the two joint tabs h downward to release and
pull out the FL connection board.
Removing the Drive motor assembly
1. Remove the two screws Y and the screw Z attaching
the bracket (2) on the back of the front panel.
2. Remove the screw A' attaching the drive motor
assembly. Release the joint tab i and pull out the
drive motor assembly.
h
FL connection board
1-14
(See Fig.39~41)
Y and the screw Z
(See Fig.39, 40,42)
h
CN441
Fig.41
FL connection board
CN441
Y
Bracket(2)
Fig.39
Bracket(2)
Z
Drive motor
Fig.40
A'
i
Fig.42
Front panel
Y
Front panel
Drive motor