Rear Sprocket / Rear Sprocket Mounting Drum Removal And Installation - Suzuki GSX-R750 Service Manual

• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 115 N·m (11.5 kgf-m, 83.0
lb-ft)
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
• Before installing the engine sprocket cover, apply a
small quantity of grease to the clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket cover (3).
• Tighten the speed sensor mounting bolt (4) to the
specified torque.
Tightening torque
Speed sensor bolt (c): 4.5 N·m (0.45 kgf-m, 3.0 lb-
ft)
1
(a)
I837H1310007-01
2
(b)
I837H1310008-01
3
4
(c)
I837H1310009-01
Drive Chain / Drive Train / Drive Shaft:
• Fit the gearshift link arm to the gearshift shaft so that
the gearshift lever is located at height "a" above the
footrest.
Gearshift lever height "a"
Standard: 65 – 75 mm (2.6 – 3.0 in)
• Adjust the drive chain slack. Refer to "Drive Chain
Inspection and Adjustment in Section 0B (Page 0B-
15)".
Rear Sprocket / Rear Sprocket Mounting Drum
Removal and Installation
Removal
1) Remove the rear wheel assembly by disengaging
the drive chain. Refer to "Rear Wheel Assembly
Removal and Installation in Section 2D (Page 2D-
11)".
2) Draw out the rear sprocket mounting drum (1) along
with the rear sprocket (2) from the wheel hub.
3) Remove the rear sprocket nuts (3) and separate the
rear sprocket (2) from its mounting drum (1).
3
2
" a "
I837H1310010-01
B838H23106003
1
3
I838H1310002-01
3A-3