Oil Jet / Oil Gallery Jet Inspection - Suzuki GSX-R750 Service Manual

Oil Jet (For Transmission)
Removal
1) Remove the engine assembly. Refer to "Engine
Assembly Removal in Section 1D (Page 1D-19)".
2) Separate the crankcases, upper and lower. Refer to
"Engine Bottom Side Disassembly in Section 1D
(Page 1D-47)".
3) Remove the oil jet (1) (for transmission) from the
lower crankcase.
1
Installation
Installation is in the reverse order of removal.
Oil Gallery Jet
Removal
1) Remove the generator cover and gasket. Refer to
"Generator Removal and Installation in Section 1J
(Page 1J-4)".
2) Remove the oil gallery jet (1).
1
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• Apply thread lock to the oil gallery jet and tighten it to
the specified torque.
NOTE
After tighten the jet, make sure that the jet
end is flush with the cover mating surface.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Oil gallery jet (a): 27 N·m (2.7 kgf-m, 19.5 lb-ft)
I837H1150026-01

Oil Jet / Oil Gallery Jet Inspection

Refer to "Oil Jet / Oil Gallery Jet Removal and
Installation (Page 1E-9)".
Oil Jet
Make sure that the oil jets are not clogged. If they are
clogged, clean their oil passage using a wire of the
proper size and compressed air.
I837H1150027-01
Engine Lubrication System:
(a)
2
1
1. Piston cooling jet
2. Oil jet (For transmission)
3. Oil jet (For cam chain tension adjuster)
1E-11
I837H1150028-01
B838H21506010
3
I837H1150029-01