Suzuki GSX-R750 Service Manual page 310

1D-66 Engine Mechanical:
• Tighten the water inlet connector mounting bolts (3) to
the specified torque.
Tightening torque
Water inlet connector mounting bolt (b): 10 N·m (
1.0 kgf-m, 7.0 lb-ft)
Generator Rotor / Starter Driven Gear
Install the generator rotor (1). Refer to "Generator
Removal and Installation in Section 1J (Page 1J-4)".
Cam Chain / Cam Chain Tensioner / Cam Chain
Guide
• Install the cam chain (1).
• Apply a small quantity of thread lock to the cam chain
tensioner bolt (2) and cam chain guide No. 1 bolt (3).
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
3
(b)
3
(b)
I837H1140158-02
1
I837H1140159-01
• Tighten the cam chain tensioner bolt (2) and cam
chain guide No. 1 bolt (3).
Tightening torque
Cam chain tensioner bolt (a): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
Cam chain guide No. 1 bolt (b): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
2
(a)
1
• Install the CKP sensor rotor/cam chain drive sprocket
(4) onto the crankshaft.
NOTE
When installing the cam chain drive sprocket,
align the wide spline tooth "A" and "B".
• Set the cam chain onto the teeth "C".
"B"
3
(b)
I837H1140160-02
"A"
"C"
4
I837H1140161-01