1D-74 Engine Mechanical:
2) Remove the washers, balancer gear and dampers
from the shaft.
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Apply molybdenum oil solution to each part.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Set the dampers and install the balancer shaft to
balancer gear.
NOTE
• Fit the stopper of the balancer shaft
between the dampers.
• Align the line "A" on the balancer shaft
with the punch "B" on the balancer gear.
"B"
"A"
Balancer Shaft Inspection
Refer to "Balancer Shaft Disassembly and Assembly
(Page 1D-73)".
Balancer Shaft
Inspect the balancer shaft for wear or damage. Replace
the balancer shaft if there is anything unusual.
Damper
Inspect the dampers for wear and damage, replace them
if any defects are found.
Balancer Shaft Journal Bearing Removal and
I838H1140054-01
Installation
Refer to "Engine Bottom Side Disassembly (Page 1D-
47)".
Refer to "Engine Bottom Side Assembly (Page 1D-55)".
Removal
Remove the balancer shaft journal bearings (1).
NOTE
• Do not remove the bearings (1) unless
absolutely necessary.
• Make a note of where the bearings are
removed from so that they can be
reinstalled in their original positions.
CAUTION
!
When removing the bearings, be careful not
to scratch the bearings.
I838H1140055-01
B838H21406037
I838H1140054-01
B838H21406038
1
I838H1140056-02
1
I838H1140057-02