Acl - Planet ADE-4400 User Manual

Field
Password
Debug
Show Message
CPE sends GetRPC
Skip MReboot
Delay
Auto-Execution

3.5.6 ACL

Choose Service > ACL, the page shown in the following figure appears. In this page, you
can permit the data packets from LAN or WAN to access the router. You can configure the
IP address for Access Control List (ACL). If ACL is enabled, only the effective IP address
in the ACL can access the router.
Note:
If you select Enable in ACL capability, ensure that your host IP address is in ACL list
before it takes effect.
The following table describes the parameters and buttons of this page:
Field
Direction Select
LAN ACL Switch
IP Address
Services Allowed
Add
Reset
Description
The connection password provided by TR-069 service.
Select Enable to display ACS SOAP messages on the
serial console.
Select Enable, the router contacts the ACS to obtain
configuration updates.
Specify whether to send an MReboot event code in the
inform message.
Specify whether to start the TR-069 program after a short
delay.
Specify whether to automatically start the TR-069 after the
router is powered on.
Description
Select the router interface. You can select LAN or WAN. In this
example, LAN is selected.
Select it to enable or disable ACL function.
Enter the IP address of the specified interface. Only the IP address
that is in the same network segment with the IP address of the
specified interface can access the router.
You can choose the following services from LAN: web, telnet, ftp,
tftp, snmp, or ping. You can also choose all the services.
After setting the parameters, click it to add an entry to the Current
ACL Table.
Click it to refresh this page.
44