The following table describes the parameters and buttons of this page:
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Update
Delete Selected
Show Routes
Static Route Table A list of the previously configured static IP routes.
Click Show Routes, the page shown in the following figure appears. The table shows a
list of destination routes commonly accessed by your network.
3.6.2.2 IPv6 Static Route
Click IPv6 Static Route in the left pane, the page shown in the following figure appears.
This page is used to configure the IPv6 routing information. You can add or delete IP
routes.
Description
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to
the destination device.
The metric cost for the destination.
The interface for the specified route.
Click it to add the new static route to the Static Route
Table.
Select a row in the Static Route Table and modify the
parameters. Then click it to save the settings
temporarily.
Select a row in the Static Route Table and click it to
delete the row.
Click it, the IP Route Table appears. You can view a list
of destination routes commonly accessed by your
network.
47