Snmp - Planet ADE-4400 User Manual

Field
Schedule Mode
Source IP
Source Mask
Destination IP
Destination Mask The subnet mask of the destination IP address.
Source Port
Destination Port
Protocol
Physical Port
Set priority
IP Precedence
IP ToS
802.1p
delete
delete all

3.6.5 SNMP

Choose Advance > SNMP, the page shown in the following figure appears. You can
configure the SNMP parameters.
The following table describes the parameters of this page:
Field
Enable SNMP
Trap IP Address
Community name
(read-only)
Community name
(write-only)
Description
You can choose strict prior or WFQ (4:3:2:1).
The IP address of the source data packet.
The subnet mask of the source IP address.
The IP address of the destination data packet.
The port of the source data packet.
The port of the destination data packet.
The protocol responds to the IP QoS rules. You can choose TCP,
UDP, or ICMP.
The LAN interface responds to the IP QoS rules.
The priority of the IP QoS rules. P0 is the highest priority and P3 is
the lowest.
You can choose from 0 to 7 define the priority in the ToS of the IP
data packet.
The type of IP ToS for classifying the data package
You can choose Normal Service, Minimize Cost, Maximize
Reliability, Maximize Throughput, or Minimize Delay.
You can choose from 0 to 7.
Select a row in the QoS rule list and click it to delete the row.
Select all the rows in the QoS rule list and click it to delete the rows.
Description
Select it to enable SNMP function. You need to enable
SNMP, and then you can configure the parameters of
this page.
Enter the trap IP address. The trap information is sent
to the corresponding host.
The network administrators must use this password to
read the information of this router.
The network administrators must use this password to
configure the information of the router.
51