Dhcp - Planet ADE-4400 User Manual

Adsl 2/2+ 4-port router
Hide thumbs Also See for ADE-4400:
Table of Contents

Advertisement

Field
Enable
M flag/O flag
Max Interval
Min Interval
Prefix mode
Prefix Address Type the Prefix address on this item.
Prefix Length
Preferred
Time
Valid Time
The following table describes the DHCPv6 setting parameters of this page:
Field
DHCPv6 Mode
IPv6 Address Pool
Prefix Length
Preferred Time
Valid Time
DNS servers

3.4.1.3 DHCP

Dynamic Host Configuration Protocol (DHCP) allows the individual PC to obtain the
TCP/IP configuration from the centralized DHCP server. You can configure this router as a
DHCP server or disable it. The DHCP server can assign IP address, IP default gateway,
and DNS server to DHCP clients. This router can also act as a surrogate DHCP server
(DHCP proxy) where it relays IP address assignment from an actual real DHCP server to
clients. You can enable or disable DHCP server or DHCP proxy.
Click DHCP in the left pane, the page shown in the following figure appears.
Description
Check the box to enable the RA mode.
The different flag combination can change the IPv6 IP
address assign mode.The direction as below:
M=1, O=0 or 1:The PC will obtained the prefix and DNS from
DHCPv6 (Stateful DHCPv6)
M=0, O=1: The PC will use the prefix in RA,but the DNS will
obtained by DHCPv6 (Stateless DHCPv6)
M=0, O=0: The PC will obtained the prefix but not obtained
the DNS (Stateless auto configuration)
The max RA release time interval, the default is 600 seconds.
The min RA release time interval, the default is 200 seconds.
You can select the Auto or Manual.
Means the network ID length, the range is 16-64 bit.
It must be small than or equal to the valid time, if it due, the
IPv6 address can't active create the new connect
The keep valid status time.
Description
You can select the None, Auto mode or Manual mode.
You can set the IPv6 address pool on this item.
Means the network ID length, the default value is 64 bit.
It must be small than or equal to the valid time, if it due,
the IPv6 address can't active create the new connect
The keep valid status time, default value is 120 seconds
You can set the DNS server on this item, the default
value is fe80::1.
28

Advertisement

Table of Contents
loading

Table of Contents