3.8.2 Ping6
Choose Diagnostic > Ping6. The page shown in the following figure appears.
The following table describes the parameter and button of this page:
Field
Target Address
Interface
Run Ping
3.8.3 ATM Loopback
Choose Diagnostic > ATM Loopback. The page shown in the following figure appears.
In this page, you can use VCC loopback function to check the connectivity of the VCC.
The ATM loopback test is useful for troubleshooting problems with the DSLAM and ATM
network.
Click Run Lookback to start testing.
3.8.4 ADSL
Choose Diagnostic > ADSL. The page shown in the following figure appears. It is used
for ADSL tone diagnostics.
Description
Enter the valid IP address or domain name.
Select the interface on this item.
Click it to start to Ping.
56