Konica Minolta bizhub 160f Service Manual page 161

13. Service Mode (bizhub 160f/bizhub 161f)
C. LEADING EDGE ERASE
Functions • To change the laser emission timing to adjust the width of the image area that is
Use • When the PH unit has been replaced
• When the user requests a smaller margin
Adjustment Speci-
fication
Adjustment To reduce the margin........ Decrease the setting.
Instruction To increase the margin..... Increase the setting.
Adjustment 1. Enter Service's Choice in the Service mode.
Procedure 2. Select "LEADING EDGE ERASE."
3. Specify the setting.
4. Specify settings for the "TRAILING EDGE ERASE" and the "VERTICAL EDGE
D. TRAILING EDGE ERASE
Functions • To change the laser emission timing to adjust the width of the image area that is
Use • When the PH unit has been replaced
• When the user requests a smaller margin
Adjustment Speci-
fication
Adjustment To reduce the margin........ Decrease the setting.
Instruction To increase the margin..... Increase the setting.
Adjustment 1. Enter Service's Choice in the Service mode.
Procedure 2. Select "TRAILING EDGE ERASE."
3. Specify the setting.
4. Specify settings for the "LEADING EDGE ERASE" and the "VERTICAL EDGE
128
erased at the leading edge.
A
4022D503AA
ERASE" functions in the same way.
erased at the trailing edge.
4022D503AA
ERASE" functions in the same way.
Confidential – for internal use only, do not distribute
Field Service Ver. 1.0 Apr. 2005
•Specify the amount erased at the leading
edge (width of A) of the paper.
Specifications
0 ± 2.0 mm
Setting Range
0 to 5 (1 increment = 1 mm)
The default setting is "4" mm
•Specify the amount erased at the trailing
B
edge (width of B) of the paper.
Specifications
0 ± 2.0 mm
Setting Range
0 to 5 (1 increment = 1 mm)
The default setting is "4" mm