Head Restraints - Skoda Superb Owner's Manual

80 Seats and Stowage
If you wish, you can obtain an additional remote control key from an authorised
Škoda Service partner and then assign the remote control key to another memory
button.
Note

If the remote control had previously been assigned to another memory button,
this setting is then erased by the new assignment.

If you assign the remote control to a memory button which has already been
assigned to a remote control, the old assignment is also replaced by a new assign-
ment in this case.

The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.

After the successful assignment, the turn signal lights flash and an audible
signal will sound as a confirmation. The setting is stored with the memory button
which you have selected.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory buttons
or with the remote control.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibilities:
– One-touch automatic memory: briefly press the desired memory button
 page 79, fig.
71. The seat and exterior mirror are moved automatically into the
stored positions (this applies only if the ignition is switched on and the speed is
less than 5 km/h).
– Memory keying: Press and hold the desired memory button
enough until the seat and the exterior mirror are moved into the stored posi-
tions.
Retrieving settings with remote control
– If the driver door is closed and the ignition is switched off, briefly press the
unlock button of the remote control  page 49 and then open the driver door.
– The seat and exterior mirrors now move automatically into the stored positions.
Retrieving setting of exterior mirror for reversing
– Turn the rotary knob for the exterior mirror setting into the position
before engaging the reverse gear.
The mirror returns into its initial position, after the rotary knob is moved out of the
position  and put into another position or if the speed is more than 15 km/h.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.

Head restraints

Fig. 72 Head restraint: Adjusting/pulling out
A
B
Best protection is achieved if the top edge of the head restraint is at the same level
as the upper part of your head.
A
pressed long
B
Adjusting the height of a head restraint
– Grasp the side of the head restraint with both hands and push it in upward direc-
tion as desired
– Move the head restraint downwards if required by pressing and holding the
safety button with one hand
hand the head restraint downwards.
Removing and installing a head restraint
– Pull the head restraint up out of the seat backrest as far as the stop (on the rear
head restraints fold forward the seat backrest).
 fig. 72
- left.
 fig. 72
- right and by pressing with the other
  page 75