Skoda Superb Owner's Manual page 129

Hide thumbs Also See for Superb:
Table of Contents

Advertisement

128
Starting-off and Driving
The set speed remains stored in the memory.
The Resumption of the stored speed is achieved by releasing the brake or clutch
pedal, on vehicles fitted with automatic gearbox only after releasing the brake
pedal and after shortly pressing the rocker button
position RES.
WARNING
First ensure that it is not too high for the traffic conditions which exist at that
moment before resuming the stored speed.
Switching off the cruise control system completely
A
 page 127, fig. 138
Press the switch
A
"(START-STOP)"
The "START-STOP" system helps you to save fuel while at the same time reducing
harmful exhaust emissions and CO
The function is automatically activated each time the ignition is switched on.
In the start-stop mode, the engine automatically switches to the vehicle's idle
phase, e.g. when stopped at traffic lights.
Information regarding the current state of the "START-STOP" system is indicated in
the display of the instrument cluster.
Automatic engine shut down (stop phase)
Stop the vehicle (where necessary, apply the handbrake).
A
 page 127, fig. 138
B
to the right into position OFF.
Fig. 139 START-STOP System button
emissions.
2
Take the vehicle out of gear.
Take your foot off the clutch.
into the
Automatic engine restart (start phase).
Push down on the clutch.
Switching the "START-STOP" system on and off
You can switch the "START STOP" system on/off by pressing the button
When start-stop mode is deactivated, the warning light in the button lights up.
If the vehicle is in the stop phase when manually switching off the system, the
engine starts immediately.
The "START-STOP" system is very complex. Some of the procedures are hard to
check without servicing. The general conditions for the proper functioning of the
"START-STOP" system are listed in the following overview.
Conditions for the automatic engine shut down (stop phase)
The gearshift lever is in Neutral.
The clutch pedal is not pressed!
The driver has fastened the seat belt.
The driver's door is closed.
The bonnet is closed.
The vehicle is at a standstill.
The factory-fitted towing device is not electrically connected to a trailer.
The engine has reached its operating temperature.
The charge state of the vehicle battery is sufficient.
The stationary vehicle is not on a steep slope or a steep downhill section.
The engine speed is less than 1200 1/min.
The temperature of the vehicle battery is not too low or too high.
The pressure in the brake system is sufficient.
The difference between the outdoor- and the set temperature in the interior is
not too great.
 fig.
139.

Advertisement

Table of Contents
loading

Table of Contents