Setting The Top Position Of The Lid; Operational Problems - Skoda Superb Owner's Manual

Signals
Interrupted tone
1 continuous tone
3 rising tones
3 identical tones
Note
A
The expansion of the area
3
on the setting of the top position of the lid  page 47. When setting the top posi-
A
tion of the lid in the area , the area
2
changes proportionally to the set top position of the lid.

Setting the top position of the lid

If the space for opening the lid is restricted (e.g. height of garage) or for more
convenient operation (e.g. according to a person's height), it is possible to set the
boot lid in the top position.
Setting the top position of the lid
– Stop the lid in the desired position (electrically or manually).
A
– Press the inner button
B
seconds. Storing the position in the memory of the control unit is confirmed with
an audible signal.
Deleting the set position of the lid
– Carefully lift up the lid manually to the maximum opening position.
A
– Hold the inner button
B
sounds and the height which was originally set is deleted from the memory of
the control unit, while the basic position of the top lid position is again set.
Using the system Safety
Status
Open (using the button on the remote
control key or the button on the centre
console  page 45, fig.
Force limiter
Confirmation of the storage of the lid
position
fault
 page 46, fig. 35
changes proportionally, depending
A
is not active, the expansion of the area
3
 page 45, fig. 33
and hold it pressed for approx. 3
pressed for approx. 3 seconds. An audible signal
Driving Tips
Note

The lid always opens at the height which was last stored in the memory of the
control unit.

34)
The top position which is reached when the lid opens automatically, is always
lower than the maximum top position which can be reached when the lid is opened
manually.

Operational problems

If the battery is disconnected and reconnected while the boot lid is open, it is neces-
sary to activate the system of the electric boot lid. Activating means the initialisa-
tion of the control unit by manually closing the lid. Thus, the end position of the lid
is stored under fully closed in secured lock.
Possible malfunctions of the electric boot lid:
A
2
Examples of operational malfunctions
Description of the malfunction
The lid cannot be lifted out of the lock.
The lid does not react to an opening sig-
nal
The lid remains in the top position
Note
Contact your specialist garage if there is a malfunction of the electric boot lid.
General Maintenance
Unlocking and locking
Possible solutions
Emergency unlocking of the lid
 page 48
Remove the possible obstacle (e.g.
snow), open the lid again  page 46
Press the handle on the lower edge of
the boot lid and pull the lid upwards
Manually close the lid (slowly and with-
out sudden movements)
Breakdown assistance Technical Data
47