Skoda Superb Owner's Manual page 146

rSAP - Remote SIM access profile
After connecting the telephone with the hands-free system via the rSAP profile, the
telephone deregisters from the GSM network, the control unit ensures the commu-
nication with the network via the internal antenna. In the telephone only the inter-
®
face for Bluetooth remains active. In this case, you can only separate from the
control unit, switch off the Bluetooth
emergency call 112 (only valid for some countries).
HFP - Hands Free Profile
After connecting the telephone with the hands-free system via the HFP profile, the
telephone continues to use its GMS module and internal antenna to communicate
with the GSM network.
WARNING
Pay attention primarily to the traffic situation! As the driver you are fully respon-
sible for road safety. Use the telephone system only to such an extent, so that
you are in full control of your vehicle at any time.
Note

The volume can be changed individually during the call at any time with the
button for setting the radio or radio navigation system or with the buttons on the
multifunction steering wheel.

Please refer to the following guidelines  page 138, "Mobile phones and two-
way radio systems".

Should you have any questions, please contact an authorised Škoda Service
Partner.
Phone Phonebook
A phone phonebook is part of the mobile phone preinstallation with voice control.
In the phone phonebook there are 2 000 free memory locations available. Each
contact can contain up to 5 numbers. This phone phonebook can be used in line with
the mobile telephone.
On vehicles fitted with the radio navigation system Columbus, a maximum of 1000
telephone contacts are shown in the display of this appliance.
After the first connection of the telephone, the system begins to load the phone
book from the phone and the SIM card into the memory of the control unit.
If the telephone book of the mobile phone contains more than 2 000 entries, the
system announces Phone book not fully loaded.
Using the system Safety
®
connection or select the number of the
Driving Tips
Each time the telephone has established a new connection with the hands-free
system, an update of the relevant phone book is performed. The updating can take
a few minutes. During this time the phone book, which was stored after the last
update was completed, is available. Newly stored telephone numbers are only
shown after the updating has ended.
If a telephone event (e.g. incoming or outgoing call, dialogue of the voice control)
occurs during the updating procedure, the updating is interrupted. After the tele-
phone event has ended, the updating starts anew.
Connection of the telephone with the hands-free system
In order to connect a mobile phone with the hands-free system, it is necessary to
connect the telephone to the hands-free system. Detailed information on this is
provided in the operating instructions of your mobile phone. The following steps
must be carried out for the connection.
Connecting the telephone with the hands-free system via the HFP
profile
®
– Activate the Bluetooth in your telephone and the visibility of the mobile phone.
– Switch on the ignition.
– Select the menu Phone - Phone search in the information display and wait until
the control unit has ended the search.
– Select your mobile phone in the menu of the units found.
– Within 30 seconds enter the 16 digit PIN of your control unit as indicated in the
information display and confirm it according to the instructions on the display of
your telephone.
– To store a new user or to download the telephone book and the identification
data of the SIM card into the control unit, follow the instructions in the informa-
tion display and on the mobile phone.
Connecting the telephone with the hands-free system via the rSAP
profile
®
– Activate the Bluetooth in your telephone and the visibility of the mobile phone.
For certain mobile phones it is necessary to switch on first the rSAP function.
– Switch on the ignition.
– Select the menu Phone - Phone search in the information display and wait until
the control unit has ended the search.
General Maintenance Breakdown assistance
Communication 145
Technical Data