Rear Light Unit - Skoda Superb Owner's Manual

238 Fuses and light bulbs
– Open the bonnet.
A
– Remove the protective cap
B
– Turn the connector with the light bulb up to the stop towards the left and
 page 237, fig.
remove 217.
– Replace the lamp, insert the connector with the new lamp and turn to the right
up to the stop.
– Insert the protective cap.
Note
We recommend that you have the headlight setting checked by a Skoda Service
Partner after replacing the light bulb.
Fog lights
Fig. 218 Front bumper: Cover/fog lights with daylight driving lights
Replacing bulbs
– Switch the ignition and all lights off.
– Grasp the cover at the points marked with the arrows
it out.
– Guide your hand into the opening, in which the cover was located, and press the
A  fig.
spring bolt 218.
C
– Take out the fog light.
A A
– Turn the socket or with the bulb to the left up to the stop and take it out.
A B
– Replace the lamp, insert the connector with the new lamp and turn to the right
up to the stop.
 page 237, fig.
215.
 fig. 218
- left and take
– For the installation, first of all insert the fog light with the interlock to the side
far away from the marking of the vehicle.
– Press into place the headlight onto the side facing the marking. The spring bolt
must engage firmly.
– In order to reinstall the cover, first of all insert one part of the cover starting on
the side facing the fog light. Then press the cover closed on the side facing the
marking. The cover must engage firmly.
A
- bulb for daylight driving lights.
A
A - bulb for fog lights.
B

Rear light unit

Fig. 219 Remove the outer part of the rear light unit/remove the inner part of the rear light unit
Remove and install the outer part of the rear light unit
– Switch the ignition and all lights off.
– Open the boot lid/luggage compartment door.
 fig. 219
– Take out the plugs - left and unscrew the rear light unit using a torx
18)
wrench .
– Carefully take out the lamp. Do not pull the grommet with the cables out of the
body.
– To re-insert the rear light unit, first of all guide it with the support
 page 239, fig. 220
towards the front onto a bolt on the bodywork.
– Carefully press the rear light unit into the bodywork.
18)
The torx wrench is located in the vehicle toolkit box.
A
A