Tyre Repair Kit - Skoda Superb Owner's Manual

224 Breakdown assistance
Securing wheels against being stolen
You need a special adapter for slackening the safety wheel bolts.
– Pull off the full wheel trim/cap from the wheel hub or cap from the safety wheel
bolt.
A
– Insert the adapter with its toothed side fully into the inner toothing of the
B
safety wheel bolt A right down in such a way that only the outer hexagon is
A
 fig.
jutting out 203.
– Insert the wheel wrench fully onto the adapter
– Slacken the wheel bolt, or tighten it firmly  page 223.
– Reinstall the full wheel trim/wheel cap after removing the adapter or place the
cap onto the safety wheel bolt.
– Have the tightening torque checked with a torque wrench as soon as possible.
Steel and light alloy wheels must be tightened to a tightening torque of 120 Nm.
The safety wheel bolts on vehicles fitted with them (one safety wheel bolt per
wheel) can only be loosened or tighten up by using the adapter provided.
It is meaningful to note the code number hammered into the rear side of the
adapter or the rear side of the safety wheel bolts. You can obtain a replacement
adapter from an authorised Škoda Service Partner, if necessary, by quoting this
number.
We recommend that you always carry the adapter for the wheel bolts with you in
the vehicle. It should be stowed in the vehicle tool kit.
Caution
Damage can occur to the adapter and safety wheel bolt if the safety wheel bolt is
tightened up too much.
Fig. 203 Illustration image: Safety wheel
bolt with adapter
A .
B
Note
The set of safety wheel bolts can be obtained from an authorised Škoda Service
Partner.

Tyre repair kit

General information
The tyre repair kit is located in a box under the carpet in the luggage compartment.
Use the tyre repair kit to reliably repair tyre damage caused by foreign bodies or a
puncture with diameters up to 4 mm. Do not remove foreign bodies, e.g. screws or
nails, from the tyre!
The repair can be undertaken on the vehicle immediately.
The repair with the tyre repair kit is not at all intended to replace a permanent
repair on the tyre, this repair only serves to reach the next specialist garage.
Do not use the tyre repair kit:

to repair wheel damage,

in outside temperatures of less than -20 °C (-4 °F),

with tears or punctures greater than 4 mm in size,

to repair damage to the tyre wall,

when driving with very low tyre pressure or with a completely flat tyre,

if the use-by-date (see inflation bottle) has passed.
WARNING

If you find yourself in flowing traffic switch on the hazard warning lights
system and place the warning triangle on the side of the road at the prescribed
distance from your vehicle. Comply with the national legal regulations. In this
way you are protecting not only yourself but also other road users.

Park the vehicle as far away as possible from the traffic flow. Park on as flat
and firm a surface as possible.

A tyre filled with sealant has the same driving characteristics as a standard
tyre.

Do not drive faster than 80 km/h, 50 mph.

Avoid accelerating at full throttle, sharp braking and fast cornering.