Skoda Superb Owner's Manual page 74

When the rain sensor is active (the lever is in the position
active if the front window wipers continue to operate (no break between each
wiping process).
Activation/deactivation
The function of the automatic rear window wiper is activated/deactivated in the
information display in the menu:
Settings

Lights & Vision

Rear wiper

Note
The function of the automatic rear window wiper is only valid for Combi vehicles
which are equipped with an Iinformation display. The function is activated in the
factory.
Alternative park position of the rear window wiper (Combi)
Each time after switching off the engine for the second time, the wiper blade of the
rear window wiper is tilted. Thus, the life of the wiper blade is prolonged.
Activation/deactivation
– Switch on the ignition.
– Push the operating level into the position
succession within 5 seconds.
– Switch off the ignition. After switching on the ignition again, the alternative park
position of the rear window wiper is activated/deactivated.
Headlight cleaning system
The headlights are being cleaned after the windscreen has been sprayed for the
first time and fifth time, the low beam or main beam are switched on and the wind-
screen wiper lever was held in the position
The headlight washer nozzles are moved forward out of the bumper by the water
pressure for cleaning the headlights.
You should remove stubborn dirt (such as insect residues) from the headlight lenses
at regular intervals, for example when refuelling. Please refer to the following
guidelines  page 195, "The headlight lenses".
Using the system Safety
A
) the function is only
1
A  page 71, fig. 64
five times in
6
A  page 71, fig. 64
for about 1 second.
5
Driving Tips
You should remove any snow from the fixtures of the washer nozzles and clear ice
in winter with a de-icing spray in order to ensure proper operation of the cleaning
system.
Caution
Never remove the nozzles from the headlamp cleaning system by hand - risk of
damage!
Replacing wiper blades for the windscreen wipers
One cannot fold out the wiper arms in the rest position from the windscreen. Before
replacing the wiper arms you must put them into the service position.
Service position for changing wiper blades
– Close the bonnet.
– Switch the ignition on and then again off.
– Then press the windscreen wiper lever in the position
within 10 seconds - the wiper arms move into the service position.
Removing the wiper blade
– Fold windscreen wiper arm away from the windscreen.
– Press the locking button A  fig.
1
off in the direction of the arrow
Attaching the wiper blade
– Push the wiper blade until it locks up to the stop.
General Maintenance Breakdown assistance
Lights and Visibility
Fig. 65 Wiper blade for the windscreen
wiper
A  page 71, fig. 64
4
65, in order to unlock the wiper blade and pull
A
.
2
Technical Data
73