Memory; Basic Operation - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Introduction
This device complies with FCC Part 15 and Industry Canada RSS 210 subject to the
following conditions:
1. This device must not cause harmful interference and
2. This device must accept all interference, including interference that interferes with
the operation of this device.

Memory

The MVP-5200i comes with 128MB of Mobile DDRAM memory and 256 MB NAND Flash memory. Neither
may be upgraded.
Table Charging Station Connector Locations
With the unit facing you, the mini-USB port (for programming and downloading firmware as well as
connecting USB headphones using the AMX-provided adaptor cable) and the DC power port are located on
the lower left side of the device (FIG. 3). The connector for the Table Charging Station (please refer to the
Table Charging Station section on page 9) is located on the bottom of the device.
FIG. 3 MVP-5200i side view with programming port
Although firmware upgrades can be conducted over a wireless Ethernet connection,
transferring firmware KIT files over a direct USB connection is recommended, and
only when the panel is connected to a power supply. If battery power or wireless
connection fails during a firmware upgrade, the panel flash file system may become
corrupted.
In addition to its speaker, the MVP-5200i also utilizes its mini-USB port as a connector for standard
headphones or headsets. These headphones must use a mini-USB plug or adaptor in order to utilize this
feature.
While standard input/output headsets may be used in lieu of headphones, the
headset may only be used for output. While you may receive sound from the headset,
its microphone will not function. Always use the MVP-5200i's microphone for
receiving sound.

Basic Operation

The MVP-5200i is operated using both its integral touchscreen and the navigation wheel on the right side of
the device. If the device has gone into its Standby Mode, a touch of the touchscreen or of the button wheel will
reactivate it.
The MVP-5200i device's power use allows up to 96 hours of use between rechargings of its internal battery,
but its battery charge lasts up to 120 hours if the device goes into Shutdown Mode during that time. The device
may be placed in its charging cradle at any time and operated within its cradle.
The device will automatically go into Sleep Mode after fifteen minutes of inactivity, and this limit may be
changed at any time. Any wireless Internet connection intended for the device will be reconnected within
approximately twenty seconds after the device is placed in its charging cradle. Depending upon preselected
settings, the device may be set to go into Active Mode as soon as it is placed in the cradle.
4
DC power port
Front
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Mini-USB port
Table Charging
Station Connector