Battery Replacement; Read These Instructions First; Replacing The Battery - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Battery Replacement

The touch panel's battery is intended to last the life of the device, but in cases where the battery has reached its
effective end of life, it may be replaced with the MVP-BP-5X Battery Pack Kit (FG5966-27).

READ THESE INSTRUCTIONS FIRST!

To minimize the risk of damage to the battery during installation, all replacement batteries come in a protective
metal cover. This cover cannot be removed from the battery.

Replacing the Battery

Before replacing the battery, download and install the latest firmware for the MVP-5200i. This firmware is
available at www.amx.com.
IMPORTANT: Prior to battery removal, run the device until the battery is completely
discharged. Do NOT discharge the battery before installing the latest MVP-5200i
firmware (v2.66.17 or later), available at www.amx.com.
To remove an old battery and replace it:
1.
Remove the battery from its packaging, remove the protective film from the battery, and inspect it for any
damage or distortion. If the battery shows evidence of damage, contact AMX for replacement and proper
disposal information.
2.
Place the device face-down on a surface that will not scratch the unit and remove the five screws from the
back of the device (FIG. 89).


FIG. 89 Screw placement at the back of the MVP-5200i- GW
The three bottom screws are shorter than the top two screws. The screws must be
re-assembled in their original location or the device can be damaged during
reassembly.
3.
Discharge all static electricity that may have built up on your body, either by using a static discharge strap
or by touching a nearby piece of metal.
4.
Carefully remove the back of the device and detach the battery lead at the battery connector (FIG. 90).
This will allow the back cover to be detached from the device.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Two of the screws are at the upper corners of the device, underneath rubber feet that also act as
screw covers. Remove the rubber feet to access the screws.
Lift up the kickstand and remove the label to reach the remaining three screws.
Battery Life and Replacement
IR emitter panel
Upper screw covers
Lower screws
Kickstand
149