Memory; Connector Locations; Basic Operation; Powering On The Mvp-9000I - AMX MVP-9000i-GB Instruction Manual

MVP-9000i Specif ications (Cont.)
Included Accessories:
Other AMX Equipment:

Memory

The MVP-9000i comes with 4GB internal MicroSD memory, 3.1GB of which is accessible to the user. This memory may not be
upgraded.

Connector Locations

With the unit facing you, the mini-USB port (for programming and downloading firmware and the DC power port are located on the
lower left side of the device (FIG. 1). The connector for the Table Docking Station (please refer to the Table Docking Station section
on page 21) is located on the bottom of the device.
NOTE: Although f irmware upgrades can be conducted over a wireless Ethernet connection, transferring f irmware KIT f iles over a
wired LAN, USB data stick, or USB flash card is recommended, and only when the panel is connected to a power supply. If battery
power is below 30 percent, and the touch panel is not connected to a power supply, the download will not be completed.
In addition to its speaker, the MVP-9000i also utilizes its mini-USB port as a connector for standard headphones or headsets. These
headphones must use a mini-USB plug or adapter in order to utilize this feature.
NOTE: While standard input/output headsets may be used in lieu of headphones, the headset may only be used for output. While you
may receive sound from the headset, its microphone will not function. Always use the MVP-9000i's microphone for receiving sound.

Basic Operation

The MVP-9000i is operated using its integral touchscreen, as well as the capacitive touch buttons on the left and the directional
pad on the right side of the device (FIG. 1). If the device has gone into its Sleep or Standby Modes, a button press will awaken the
device from Sleep Mode, but touching the screen is the only way to wake it from Standby Mode.
The MVP-9000i device's power use allows up to 72 hours of use between rechargings of its internal battery, but its battery charge
lasts up to one month if the device goes into Shutdown Mode during that time. The device may be placed in its charging cradle at
any time and operated within its cradle, making a wired Ethernet connection in the process.
If shut down, the device will power up when placed in a Table Docking Station or Wall Docking Station, or when external power is
applied via the PS3.0 Power Supply. If the device is in Standby Mode, the device will not turn on if its side buttons or directional pad
are touched or the device is docked. Touching the screen is the only way to wake an MVP-9000i from Standby Mode.
Any wired connection intended for the device will be reconnected within approximately twenty seconds after the device is placed in
a Table Docking Station or Wall Docking Station. Depending upon its settings, the device may be set to go into On Mode as soon as
it is placed in the Docking Station.

Powering on the MVP-9000i

The MVP-9000i may be powered on by touching and holding the touchscreen. If the device was in Sleep Mode, it will automatically
turn on when put into a Table or Wall Docking Station.

Intercom Microphone

The MVP-9000i contains a built-in microphone above the upper lefthand corner of the touch screen for video and audio
conferencing capabilities. This microphone is concealed by the casing.

Stylus

The MVP-9000i comes with a unique touchscreen stylus that slides into a storage groove on the left side of the device when not in
use. Replacement styluses may be ordered in a 3-pack (black, FG5966-21; white, FG5966-22) from www.amx.com.
MVP-9000i - Instruction Manual
• MVP-9000i Installation Guide (93-5967-01)
• PS3.0 Power Supply (FG423-30)
• Stylus (pre-installed onto the left side of the unit)
• MVP-TDS-9-GB Black Table Docking Station (FG5967-10)
• MVP-TDS-9-GW White Table Docking Station (FG5967-11)
• MVP-WDS-9-GB Black Wall Docking Station (FG5967-12)
• MVP-WDS-9-GW White Wall Docking Station (FG5967-13)
• CB-MVP-WDS9 Rough-In Box for Wall Docking Station (FG038-13)
• CB-MVP-WBS9B Rough-In Box Back for Wall Docking Station (FG038-14)
• MVP-STYLUS-52-XX Replacement Stylus, pack of 3 (Black: FG5966-21; White: FG5966-22)
• CC-MINIUSB Mini USB to PC Cable Adapter (FG5967-20)
• CSG-500 Gateway for 50 Users (FG2182-01)
• CSG-544 Gateway for 50 Users, 4 analog phone input ports, 4 PSTN output ports (FG2182-02)
• CSG-580 Gateway for 50 Users, 8 PSTN lines (FG2182-03)
• PS-POE-AT High Power PoE Injector (FG423-81)
• MicroSD card - 4GB (FG2116-81)
• MicroSD card - 8GB (FG2116-82)
• NXA-WAP1000 Smart Wireless Access Point (FG2255-51/53)
Introduction
17