Master Connection To A Virtual Master Via Ethernet - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

7.
Select the blank field Password to open the keyboard.
8.
Set the Password and select Done.
9.
Press the Back button to return to the Protected Setup page.
10.
Press the Reboot button to reboot the device and confirm changes.

Master Connection to a Virtual Master via Ethernet

When configuring the panel to communicate with a Virtual Master on your PC via
wireless Ethernet, the Master IP/URL field must be configured to match the IP
Address of the PC. Make sure to use the Virtual System value assigned to the Virtual
Master within NetLinx Studio.
Before beginning:
1.
Verify that the panel has been configured to communicate with the Wireless Access Point and confirm
that the signal strength quality bargraph is On.
2.
In NetLinx Studio, select Settings > Master Communication Settings from the Main menu to open the
Master Communication Settings dialog (FIG. 37).
FIG. 37 Master Communications Settings dialog
3.
Click the Communications Settings button to open the Communications Settings dialog (FIG. 38).
FIG. 38
Communications Settings dialog
4.
Click on the Virtual NetLinx Master radio button (from the Platform Selection section) to indicate that
you are working as a NetLinx Master.
5.
Click on the Virtual NetLinx Master radio box from the Transport Connection Option section to
indicate wanting to configure the PC to communicate with a panel. Everything else, such as the
Authentication, is greyed out because the procedure is not being made through the Master's UI.
MVP-5200i 5.2" Modero® ViewPoint® Touch Panel with Intercom
Configuring Communication
35