Charging Spare Batteries; Using The Single-Slot Cradle - Symbol PDT 8000 Series Product Reference Manual

PDT 8000 Series Product Reference Guide

Charging Spare Batteries

A spare battery can be charged using either of the single-slot cradles (CRD8000-1000S or
CRD8000-1000M) or the CHS8000-4000B.
Note: You can also use a UBC Adaptor (p/n 21-32665-33) to charge spare
batteries. Refer to the UBC 2000 Universal Battery Charge Product
Guide for more information.

Using the Single-Slot Cradle

1. Connect the cradle to a power source.
2. Slide the latches on both sides of the battery up, to ensure they are in the unlock
position.
3. Insert the battery into the Spare Battery Charging slot on the back of the cradle.
Position it with the charging contacts facing down (over charging pins) and gently
press down on the battery to ensure proper contact.
4. Lock the battery into place by sliding the latches on the battery down.
The spare battery charging LED blinks amber to indicate that the battery is charging and
turns solid amber when battery is completely charged. The battery usually charges in two
hours or less, but may take up to four hours to fully charge. See
page 1-16 for other indications.
1-14
UNLOCK
LOCK
Charge LED Indicator on