Note: If the battery in the terminal is low, the Terminal Charge LED may
flicker or turn yellow during an ActiveSync operation. The LED
returns to red when the operation is complete.
Charging Spare Batteries
To charge a spare battery, insert the battery in the spare battery charging slot in the back
of the cradle, oriented so the contacts are facing down and towards the back of the cradle.
Press the battery down into the slot until firmly seated.
The Spare Battery Charge LED turns red to indicate charging, then green when the battery
is fully charged. The battery is fully charged after approximately 2 1/2 hours.
Using the Synchronization Cable to Charge the Battery
To charge the terminal's battery using the optional Synchronization Cable:
Spare Battery
Charge LED
Figure 1-9. Charging the Spare Battery
Getting Started
1-11