Rear Chassis Removal - Husqvarna TC449 Workshop Manual

2
4
1 edition (08-2010) _Rev. 11-2010
st
GENERAL PROCEDURES
- Release springs (5), and remove manifold (6).
- Using a 12 mm Allen wrench, loosen the two nuts (7), then remove flange
(8), bushing (9), and gasket (10).
On reassembly, screw nuts (7) to a torque of 26 Nm - 2.65 Kgm - 19.18 ft/
lb
H02521
H02522

Rear chassis removal

1
- Remove saddle, side panels, number plate holder, rear mudguard, exhaust
silencer, and battery, as described in the relevant paragraphs.
- Disconnect control unit (1) and solenoid starter (2) from their mounts.
H02451
- Detach tank breather hoses (3) from tank (4).
3
H02452
E.21
H02523