Engine Removal - Husqvarna TC449 Workshop Manual

1
2
4
5
8
6
H06373
1 edition (08-2010) _Rev. 11-2010
st
GENERAL PROCEDURES

Engine removal

-
-
H02491
-
3
H02492
2
H02493
9
-
7a
A
7
Remove lower tank, throttle body, chain, and exhaust system as described
in the relevant paragraphs.
Loosen screw (1) positioned onto pump body, and drain off cooling sys-
tem.
Loosen clamps (2), and remove engine cooling hoses (3), (4) and (5).
Loosen screw (6) (with an 8 mm wrench), and detach ground cable (8).
To loosen the nut (7) retaining the "Motor positive" cable (9), it is neces-
sary to use two 8 mm wrenches: one to hold the lock nut (7a) and the other
to loose the nut (7) retaining the cable.
This operation is required to prevent stud bolt removal.
E.35