Cdi Electronic Control Unit Removal; Voltage Regulator Removal - Husqvarna TC449 Workshop Manual

2
1
1
1
2
3
GENERAL PROCEDURES

CDI electronic control unit removal

- Remove the saddle as described in the relevant paragraph.
- Remove the connector (1) from the CDI electronic control unit (2) and take
the control unit together with its anti-vibration mount out of the chassis.
H02459

Voltage regulator removal

- Remove the saddle as described in the relevant paragraph.
- Loosen the screws (1) using a 8 mm wrench.
H02460
H02461
- Disconnect the connector (2), and remove voltage regulator (3).
H02462
E.24
1 edition (08-2010) _Rev. 11-2010
st