MUTOH Osprey 75 User Manual page 38

2. Install the print head cap:
Open the maintenance cover.
Step 1 :
Put the purge plate down.
Step 2 :
Cut a poly-knit wiper into three equal pieces, and place them on the cap sponges.
Step 3 :
Notes
•
Place a piece of poly-knit wiper on the cap sponge as in the figure below so that the piece fits the
nozzle surface of the head.
•
Use the jet-wash fluid to wash the poly-knit wipers.
•
Replace the poly-knit wiper in the following cases:
The poly-knit wiper has dried.
o
Things such as ink clotting adhered to the poly-knit wiper.
o
The poly-knit wiper is dirty with ink, etc.
o
The poly-knit wiper has been used for a week. (Replace it once a week.)
o
•
If the cap sponge is too dirty or dry, replace it with a new one included in the box.
•
Be sure to re-attach the print head cap after the head cleaning.
No. Name
1 Purge plate
No. Name
1 Print head cap
2 Poly-knit wiper
3 Cap sponge
38
User's Guide – Osprey 75/102/130
Chapter 3: Basics
AP-75102, Rev. 2.0, 28/11/2007