MUTOH Osprey 75 User Manual page 15

Be careful of the following when handling the power cable.
•
Do not make any modifications to the power cable.
•
Do not place anything heavy on the power cable.
•
Do not bend, twist, or pull the power cable.
Do not wire the power cable near an equipment that generates heat.
After the print head cap is removed from the printer, move it into the accessory box. Discharge the waste
fluid from the print head cap enough so it would not spill.
Keep the print head cap away from the dust and other contaminants; otherwise the print head may become
clogged.
When opening/closing the maintenance cover, be careful not to get your fingers caught in the lid.
Do not cut a poly-knit wiper over the print head cap. Otherwise the print head may become clogged with
lint.
Be sure to remove pilling and lint on the cutting edge of poly-knit wiper. Otherwise the print head may
become clogged.
When the cap sponges and the poly-knit wipers become dry, always replace them with new ones.
Otherwise the print head may become clogged.
Keep the print head cap clean, otherwise the print head may become clogged.
When switching the power OFF, always install the print head cap. Or the nozzle may become clogged.
Carefully open/close the ink box cover to avoid finger pinching.
Be sure not to pinch your fingers while opening and closing the front cover.
When connecting the network interface, ensure the following precautions:
•
Never touch the connection terminals.
•
Do not connect different shaped cables
Wrong handling may cause an electric shock and/or fire.
Immediately after printing, the media guide and the platen are very hot. Perform work after the media guide
until the platen have cooled off.
When the sponge of the spitting box has been replaced, be careful for the waste fluid not to be spilled out.
If the waste fluid comes into contact with the grid roller, the surface of the grid roller will be damaged. And
the media feed function may be affected.
Be sure to switch the printer OFF and unplug the power cord before cleaning.
Do not use the jet-wash fluid, thinner, Benzene, alcohol, or other active agents except for the following
parts. Doing so may result a malfunction in the product.
•
Inside the maintenance cover
•
Print head surface
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
Never open the covers fixed with screws. Doing so may result in an electrical shock or a malfunction in the
printer.
User's Guide – Osprey 75/102/130
15
Chapter 1: Safety Instructions
AP-75102, Rev. 2.0, 28/11/2007