MUTOH Osprey 75 User Manual page 165

(10) Ink is not used though you performed initial ink charge.
No. Possible cause
1 Is the ink frozen?
You switched OFF the printer
2
during the initial ink charging.
The printer rarely prints correctly
3
just after initial ink charging.
(11) The media is off or damaged when loading it.
Notes
•
Remove the jammed or damaged media, see "When media jams occur".
No. Possible cause
Is the recommended media being
1
used?
The loading position of the media is
2
not correct.
Foreign material, such as piece of
3 media, is attached to the pressure
roller.
You used the printer in direct
sunlight or other locations not
4
appropriate for the specified
environment.
You used media folded, creased,
5 damaged, tore, curled, or inclined
to be curled.
(12) Media is damaged during media Initial.
Notes
•
Remove the jammed or damaged media, see "When media jams occur".
No. Possible cause
Is the recommended media being
1
used?
The loading position of the media is
2
not correct.
You did not load the media straight
3
into the printer.
Foreign material, such as piece of
4 media, is attached to the pressure
roller.
You used the printer where air from
an air conditioner blows or other
5
location not appropriate for the
specified environment.
You used folded, creased,
6 damaged, tore, curled, or inclined
to be curled media.
Solutions
Leave in room temperature for at
least 3 hours, and perform head-
cleaning a few times.
Switch ON the printer to continue
the initial ink charging.
Perform head cleaning a few times,
and check after each cleaning.
Solutions
Use a recommended media.
Load the media correctly.
Clean the pressure roller.
Use the printer in the specified
environment.
Replace the media.
Solutions
Use a recommended media.
Load the media correctly.
Load the media straight into the
printer.
Clean the pressure roller.
Use the printer in the specified
environment.
Replace the media.
165
User's Guide – Osprey 75/102/130
Chapter 7: Troubleshooting
References
"Head cleaning"
"Filling the ink - jet wash
fluid"
"Head cleaning"
References
"Media type"
"Loading roll media"
"Cleaning inside the
printer"
"Product Specifications"
"Cautions on handling
media"
References
"Media type"
"Loading roll media"
"Loading roll media"
"Cleaning inside the
printer"
"Product Specifications"
"Cautions on handling
media"
AP-75102, Rev. 2.0, 28/11/2007