MUTOH Osprey 75 User Manual page 14

Never open the covers fixed with screws. Doing so may result in an electrical shock or a malfunction of the
printer.
Be careful when cleaning the print head, incorrect cleaning may result in clogging of the nozzles.
•
Do not touch the print head surface with bare hands.
•
Wipe out ink on the print head wiper every time when ink has been adhered to it.
Do not tilt the printer, put it against a wall, or turn it upside down. Doing so may cause ink leakage inside
the printer. Also, movement after transport is not covered by the warranty.
Have two or more people unpack and transport the printer.
When lifting the printer out of the packing box, be sure to remove the vinyl cover first, then grab the holding
sides of the printer. Lifting the printer with the vinyl cover on may cause your hands to slip and as such
drop or damage the printer.
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
Earth wires must be connected to wires or terminals that fulfil the conditions below.
•
Earth terminals of power socket.
•
Earth wires with copper morsel that is at least 650 mm under ground.
When refilling ink or jet wash fluid, always wear the protective gloves supplied with the unit.
The ink and jet wash fluid are poisonous. If skin contact occurs, wash with soap water and rinse well.
Be sure to close the lid of the main tank tightly. If the lid is not tightly closed or loose, it will cause a defect
when purging, loading or unloading the ink.
When performing the following work, always perform work with 2 people.
•
Placement of the roll media.
•
Setting of the roll media.
•
Setting of the winding unit.
When performing the head cleaning:
•
Put on the gloves supplied with the printer.
•
Only use the print head wiper supplied with the printer. Otherwise the nozzle may become clogged.
Immediately after printing, the media guide and the platen are very hot. Perform work after the media guide
and the platen have cooled off.
When cleaning the waste fluid tray, always wear the protective gloves supplied with the unit.
When cleaning the print head surface, always wear the protective gloves supplied with the unit.
When performing cleaning for long-term storage, always wear the protective gloves supplied with the unit.
Be sure to switch the printer OFF and unplug the power cord before cleaning.
Keep the printer horizontally during transportation.
Before installing options, always perform the following.
•
Switch OFF the printer.
•
Remove the power source plug from the outlet.
•
Remove all cables connected to the printer.
•
Failure to do so could result in damage to the printer or your computer.
•
Touch a metallic section of the product to remove any static electricity in your body. The electronic
components can be damaged from static electricity.
When installing options, do not touch the elements on the circuit board. The elements on the boards can be
very hot, and can cause burns.
Make sure that the distributed power cable is used. Use of a different power cable may result in electric
shock or fire.
User's Guide – Osprey 75/102/130
14
Chapter 1: Safety Instructions
AP-75102, Rev. 2.0, 28/11/2007