MUTOH Osprey 75 User Manual page 169

No. Message
Filling Ink
1
Wait for a while
Purging
2
Wait for a while
Initializing Paper
3
********
Warming up
4
Wait for a while
Washing Head
5
Wait for a while
*Capping Out*
6 Remove Head Cap on
and press ENTER
*Manual Cut Paper*
7 Cut paper
and press ENTER
*Roller Turn*
8 Take up Roll -OFF-
can not operate
9 Discharging JW
10 Injecting Jetwash
11 Power OFF
*Cap Cover Set*
12 Put Cap Cover on
and press ENTER
*Origin Pos. Check*
13 Confirm Position
and press ENTER
*Check Maintenance*
Motor [CR PF LV UD]
14
Motor [Takeup Send]
Head [KCcMmY]
*Purge End*
15 Print -> CANCEL
Purge -> ENTER.
Solutions
The printer performs ink charging.
Please wait.
The printer performs head cleaning.
Please wait.
The printer performs initial setting of media.
Please wait.
(******** indicates the media type setting mode.)
The platen heater /ink drier is warming up.
Please wait.
The print head is being cleaned for the cleaning
process of the long-term storage.
Please wait.
The print head cap is attached. Remove the print
head cap, and press the [ENTER] key.
Cut the roll media, and press the [ENTER] key of
the control panel.
The winding unit is set to "OFF". Set to "ON" on
the winding unit menu.
The jet wash fluid is being discharged the jet wash
fluid for the cleaning process of the log-term
storage or washing print head.
The jet wash fluid is being injected the jet wash
fluid for the cleaning process of the log-term
storage or washing print head.
The ink is being discharged into the print head cap
for the power OFF process.
Install the print head cap, and press the [ENTER]
Waits to determine the setup values of the origin
setup menu. Press [ENTER] key on the operation
panel.
There is the part that becomes end of the life
cycle.
•
Check the maintenance record menu.
•
Exchange the parts shown in the maintenance
record.
The Purge process during printing is completed.
Press the following keys
on the operation panel:
•
When restart printing: [CANCEL] key
•
When continue purging: [ENTER] key
169
User's Guide – Osprey 75/102/130
key.
AP-75102, Rev. 2.0, 28/11/2007
Chapter 7: Troubleshooting
References
"Filling the ink - jet wash
fluid"
"Head cleaning before
printing"
"Setting media type"
–
"Long-term storage
cleaning"
"Long-term storage
cleaning"
"Switching the power
ON/OFF"
"Roll media cutting
procedure"
"Menu setup on the
operation panel"
"Washing print head"
"Long-term storage
cleaning"
"Washing print head"
"Long-term storage
cleaning"
"Switching the power
OFF"
"Switching the power
OFF"
"Origin setup menu"
"Switching the power
ON"
See "Replacement of the
print head and CR motor"
"Head cleaning before
printing"