1-7-9. Rear Panel Assembly
1. Remove the outside panel. (Refer to Section 1-7-1.)
2. Remove the inside panel. (Refer to Section 1-7-3.)
3. Remove the connector cover. (Refer to Section 1-7-7.)
4. Remove the connector panel assembly. (Refer to
Section 1-7-8.)
5. Disconnect the coaxial cables from the two coaxial
connectors (CN10, CN13) on the DCP-44 board, and
detach the cables from the three hooks and the notch
on the MB-1111 board.
6. Disconnect the flexible card wire from the connector
(CN3) on the CI-37 board.
7. Remove the six screws (B3 x 8) , and remove the rear
panel assembly.
1-7-10. Battery Connector
1. Remove the outside panel. (Refer to Section 1-7-1.)
2. Remove the inside panel. (Refer to Section 1-7-3.)
3. Remove the connector cover. (Refer to Section 1-7-7.)
4. Remove the connector panel assembly. (Refer to
Section 1-7-8.)
5. Remove the rear panel assembly. (Refer to Section 1-
7-9.)
6. Remove the four precision screws (B2.6 x 5), and
remove the battery harness assembly.
n
Be careful that the harness should not be caught or
damaged by any other part.
1-40
CN13
CN10
Notch
Hooks
(MB-1111 board)
Flexible card wire
DCP-44 board
Coaxial cables
Rear panel assembly
B3 x 8
CN3 (CI-37 board)
B3 x 8
Battery harness assembly
Precision screws
(P2.6 x 5, TYPE1)
PDW-700/V1 (E)