Rear Panel Assembly - Sony PMW-EX1 Service Manual

2-2-8. Rear Panel Assembly

1. Refer to Sections from 2-2-1 to 2-2-5 and
disassemble the unit up to "Handle Assem-
bly" removal.
2. Refer to Section 2-2-7 and disassemble the
unit up to "Inside Panel Assembly/Outside
Panel Assembly" removal.
3. Remove the two screws of a.
4. Remove the four screws of b.
5. Disconnect the HN-319 (flexible board) from
the connector (CN101) on the ASW-65
board.
n
The life of the flexible board and the flexible
card wire will be significantly shortened if
they are folded. Be very careful not to fold
them.
6. Disconnect the harnesses from the connector
(CN1) on the RE-250 board.
7. Reinstall the rear panel assembly by revers-
ing the steps of removal.
n
After connecting the harness that has been
removed in Step 6, tuck the wires between
the RE-250 and RE-251 boards.
PMW-EX1
a
a
CN101
(ASW-65 board)
HN-319
a
: P2 lock ace 2 x 3
b
: P2 lock ace 2 x 4
b
b
Harness
CN1
(RE-250 board)
RE-251 board
RE-250 board
The wires must be
completely tucked in
Wires
2-7