Fujitsu Primergy BX620 S4 User Manual page 122

Chapter 5 Operations after OS Installation
ID Type
20 Information
21 Information
22 Warning
35 Warning
38 Information
42 Warning
■ Notes
• When the teaming function normally starts running, event logs (ID = 6 to 8) are stored at boot of the
system. This is not a problem; no action is required.
• Once a Team is setup, plural warning logs (ID = 11) and event logs (ID =15, etc.) may be stored in
the system log of the event viewer at boot of the system. This is not a problem; no action is required.
■ Detecting an error in 1Gbit/s Ethernet I/O Modules composing a team
and replacing a defective card
Follow the steps below to replace a 1Gbit/s Ethernet I/O Module composing a team.
1
Replace a 1 Gbit/s Ethernet I/O Module in the Server Blade.
2
Start the Server Blade.
3
Log on with administrator privileges.
4
Exit all running applications.
5
Click [Start] – [Settings] – [Control Panel] – [Intel
®
Intel PROSet.
6
Select the replaced LAN adapter, and right-click it.
7
Select [Remove from team].
The confirmation message may appear. Click [OK] to continue processing.
8
Delete a LAN adapter from the team, re-select the LAN adapter moved outside
the team, and right-click it.
9
Select [Add to team], and incorporate the replaced LAN adapter in the team
again.
10
Click [OK] to exit Intel
122
table: Event log messages
The primary adapter at the next priority level is preferentially handled: (Adapter name)
The secondary adapter at the next priority level is preferentially handled: (Adapter name)
The primary adapter could not detect the next probe: (Adapter name) Cause: The team
may be divided into groups.
(Team name) without one adapter is initialized. Confirm that all adapters exist and
function.
(Adapter name) has been deleted from the team.
(Adapter name) is not specified properly. The adapter cannot process the remote
management function while being a network team.
®
PROSet.
Message
®
PROSet Wired], and start