Recovering Bios Information With Server Management Tools - Fujitsu Primergy BX620 S4 User Manual

Chapter 5 Operations after OS Installation
5.3.2 Recovering BIOS Information with Server
Management Tools
If the information configured with the BIOS Setup Utility was deleted due to a drain of the built-in
server battery, etc., restore the BIOS information according to the following procedures:
Do not turn off the server during a program run.
Before starting the system, if the ServerView "OS Boot Monitoring" function is enabled, disable it (it is
"Disabled" by default).
If you start up the system while the "OS Boot Monitoring" function remains effective, the operation of
the server may become unpredictable at such times as an abrupt power interruption or restart.
If the server is operated with the "OS Boot Monitoring" function enable, enable the function again
before resuming operation. For details of ServerView, refer to "ServerView User's Guide".
1
Turn on the server and insert the "Server Management Tools" disk into the
floppy disk drive.
The window for selecting a keyboard appears.
Please select:
1 = JP Keyboard
2 = US Keyboard
Your selection
2
Select a keyboard.
Select "1" for the Japanese keyboard or "2" for the English keyboard. The Japanese keyboard is
selected by default.
3
When the DOS prompt window appears, enter the following command and
press the [Enter] key.
A:\SMT\>dir
Check that BIOS save information files "SAVECMOS.BIN" and "nvram.enu" are stored in the
floppy disk.
4
Enter the following command and press the [Enter] key to recover BIOS
information.
A:\SMT\>write.bat
5
If the BIOS information is recovered correctly, the following message appears.
NORMAL END
6
The BIOS information will be enabled after the next system restart. Restart the
server.
Perform Step 1 to display the DOS prompt window. The recovery procedure has been completed.
The server can now be turned off safely.
96