11
Looper avoiding motion
.05.10
Requirement
With the needle bar at TDC, or at 0.8 mm before TDC for H-model machines and
machines with -911/.. (pin in hole 1 or 4), the slot in eccentric 2 must be positioned exactly
under the center of the shaft.
Fig. 11 - 11
Loosen screw 1.
Bring the needle bar into the appropriate position.
Turn eccentric 2 according to the requirement.
Tighten screw 1.
3
4
1
Adjustment
3
4
1
1
2
11 - 12