Looper-To-Needle Clearance Crosswise To Sewing Direction - Pfaff 5483 Instruction Manual

Adjustment
11

Looper-to-needle clearance crosswise to sewing direction

.05.14
11 - 17
Requirement
When the looper 1 is at its right point of reversal, there must be a clearance between the
looper point crosswise to the sewing direction and the needle center of 3.2 mm.
Fig. 11 - 15
By turning the balance wheel bring the looper 1 to its right point of reversal.
Place the "3.2" blade of looper gauge 2 (Order No. 61-111 643-06) against the needle 3
with its notch facing the direction of feed.
Make sure that the driving link 4 is vertical and turn the ball pin 5 (screw 6) with the aid
of an open-ended spanner (size 6), until the looper point 1 contacts the blade.
3
3.2 mm
4
6
5
2
1