Feed Lifting Height - Pfaff 5483 Instruction Manual

11

Feed lifting height

.05.08
Requirement
With the stitch length set at its maximum and the needle bar positioned at TDC, or at 0.8
mm before TDC for model H machines and machines with -911/... (pin in hole 1 or 4), the
feed dog must be centered in its slots and its entire length must be in contact with the
adjustment gauge.
Fig. 11 - 09
Set the maximum stitch length and position the needle bar appropriately.
Place the adjustment gauge (Order No. 61-111 642-19) on the needle plate so that its
recess is centered above the feed slots (arrow pointing in feed direction) and lower the
presser foot.
Loosen screws 1 1 1 1 1 and 2 2 2 2 2 .
By turning cranks 3 3 3 3 3 and 4 4 4 4 4 and the eccentric sleeve 5 5 5 5 5 adjust the feed dog according to
the requirement.
1
5
2
4
3
Adjustment
3
4
1
3
4
1
11 - 10