8
Fitting the lower belt guard
.01.04
Fig. 8 - 04
8
Fitting the synchronizer
.01.05
3
Fig. 8 - 05
Installation and commissioning
1
4
2
1
Position belt guard 1 so that motor pulley
and v-belt can run freely.
Fig. 8-04 shows a Quick motor.
If a different motor is used,
follow the instructions of the
motor instruction manual.
Screw on stop 1 with screws 2.
Place synchronizer 3 on the shaft so that
stop 1 is in the slot of synchronizer 3,
see arrow.
Tighten screws 4 just a little.
Insert the plug for the synchronizer in the
socket on the control box.
Adjust synchronizer 3 (see Chapter
11.05.01, Adjusting the synchronizer).
8 - 3