Assembling And Fitting The Reel Stand; Commissioning - Pfaff 5483 Instruction Manual

Installation and commissioning
8

Assembling and fitting the reel stand

.01.06
8

Commissioning

.02
8 - 4
Fig. 8 - 06
Fig. 8 - 07
The machine must only be connected to a suitably earthed socket!
When the machine is running, the balance wheel must turn towards the operator; if it
does not, have a qualified person change the motor connection.
Machines with pneumatic equipment have to be connected to the compressed air
supply. The pressure gauge must show a pressure of 6 bar. If necessary have this
reading adjusted (see Chapter 10.03, Checking/adjusting the air pressure).
Assemble the reel stand as shown in
Fig. 8-06.
Fit the reel stand in the holes in the table
top and secure it with the nuts provided.
1
Clean the machine thoroughly and
afterwards check the oil level (see
Chapter 10, Care and Maintenance Chapter 10, Care and Maintenance Chapter 10, Care and Maintenance). Chapter 10, Care and Maintenance Chapter 10, Care and Maintenance
Check the machine for any damage,
especially the electrical leads.
Have a qualified person check whether
the motor can be driven with the existing
power voltage and that it is correctly
connected in the junction box.
Before setting up, remove the
protective foil from oil glass 1 1 1 1 1 !
If there are any differences, the
machine must definitely not be
operated!