Zeroing The Bottom Feed (On Machines With Open Gearcase) - Pfaff 5483 Instruction Manual

Adjustment
11 Zeroing the bottom feed
.05.05
11 - 7
Requirement
With the stitch length set at "0", the feed dog must not move when the balance wheel is
turned.
4
Fig. 11 - 06
Loosen screw 1 (see Fig. 11-05).
Set stitch length at "0".
Turn eccentric bush 2 (screw 3) so that the marking faces downward and the surface of
the eccentric bush 2 is at an angle of 45° to the front edge of the machine.
While turning the balance wheel continuously twist crank 4 (screw 5) according to the
requirement.
Screw 1 is left loose for further adjustments.
(on machines with open gearcase)
5
45°
2
3